Questo è il perno R per il foro dell'albero dell'assale posteriore..
Quando si regola la catena o si cambia un pneumatico, è necessario prima rimuovere il perno di separazione e poi allentare il dado prima di poter regolare o sostituire la catena..
Pertanto, raddrizzare le curve dei perni divisi e poi rimuoverli prima..
Poi, quando la regolazione e la sostituzione è completa, il perno diviso viene reinserito nel foro e la punta viene piegata per evitare che si stacchi, e questo è tutto..
Pertanto, se si sostituisce l'R-Pin con questo R-Pin, è facile da rimuovere con un solo tocco e facile da inserire e rifinire, quindi è facile e senza problemi..
E poiché è fatto di acciaio inossidabile, non arrugginisce mai e può essere usato più e più volte..
This is the R pin used in the rear axle shaft hole.
When you adjust the chain or change the tire, you must first remove the cotter pin from here and then loosen the nut to adjust or change the tire.
Therefore, straighten the bend of the cotter pin and remove it first.
After the adjustment or replacement, the cotter pin is inserted into the hole and the tip is bent to prevent it from coming out.
Therefore, if you replace it with this R pin, you can easily remove it by one-touch, and insert it easily to finish the work.
It is also made of stainless steel, so it will never rust and can be used again and again, making it 200% affordable.