[componenti]
1. Il faro antinebbia rimane
2. testa del bottone del bullone
3. rondella
4. occhiello
5. collare con tesa
6. Distanziatore
7. dado
8. Bullone a testa cilindrica
9. collare
[Specifiche dei fendinebbia]
Intensità massima : 4000cd
temperatura di colore : 6400K
Consumo energetico nominale : 8W (1pc)
Consumo di corrente : Circa 1A per unità
costi di produzione : 0.5h (quando la lampada e lo strallo sono installati contemporaneamente)
*Fissare il veicolo su una superficie piana per evitare che cada prima di iniziare i lavori.
*Scollegare il polo negativo della batteria prima di iniziare i lavori.
*L'accessorio elettrico massimo che può essere collegato all'alimentatore accessorio dell'unità principale è di 2A.
*Per evitare danni al cablaggio, prestare attenzione a quanto segue.
Fare attenzione a non piegare i fili e a non farli impigliare in altre parti.
Non dirigersi vicino a parti che diventano ad alta temperatura.
Controllare che il cablaggio non venga tirato quando il volante viene girato completamente a sinistra o a destra.
*Non sporgere le forchette anteriori. Il faro antinebbia può interferire con il parafango anteriore.
*Prima di partire, assicurarsi che non ci sia nessun allentamento o sonaglio in nessuna parte del veicolo.
*Per pulire il kit fendinebbia, utilizzare un detergente neutro e lavarlo con acqua utilizzando un panno morbido o una spugna. Dopo il lavaggio, strofinare bene l'acqua con un panno morbido.
*Non applicare l'acqua di un'autolavaggio ad alta pressione direttamente sulla superficie.
[Component parts]
1.Fog lamp bracket
2. Bolt button head
3. Washer
4. Grommet
5. collar with brim
6. Spacer
7. nut
8. Socket head bolt
9. color
[Fog lamp spec.]
Maximum illumination: 4000cd
Color Temperature: 6400K
Rated power consumption: 8W (1pc)
Current consumption: Approx. 1A per unit
Man-hours: 0.5h (when the lamp and bracket are installed at the same time)
*Secure the motorcycle on a flat surface to prevent it from falling before starting work.
*Remove the negative terminal of the battery before working.
*The maximum electrical accessory that can be attached to the main accessory power supply is 2A.
*To prevent damage to the wiring, pay attention to the following.
・Be careful not to bend the wires or get them caught in other parts.
・Do not route near parts that become high temperature.
・Check that the wiring is not pulled when the steering wheel is turned fully left or right.
*Do not stick out the front forks.The fog lamp may interfere with the front fender.
*Before riding, make sure that there is no looseness or rattling in any part.
*To clean the fog lamp kit, use a mild detergent and wash it with water using a soft cloth or sponge.After washing the motorcycle, wipe off the water well with a soft cloth.
*Do not direct water from high pressure bike wash machine.