*Questo prodotto è circa 65 mm indietro e 3 mm più basso in altezza rispetto alla maniglia di serie.
*La larghezza complessiva è di -5mm alla fine della leva di serie.(Larghezza complessiva:±20mm/altezza complessiva:±40mm) Non è richiesto alcun cambiamento strutturale.
*Non c'è bisogno di cambiare il tubo/cavo/cavo per questo prodotto, ma se siete preoccupati, cambiate il tubo del freno alla lunghezza appropriata. Si prega di regolare la tensione del filo dell'asse a causa del cambiamento di gestione.
*C'è un errore nello spessore della vernice su questo prodotto. Quando si gira il lato dell'asse, può essere opaco. In questo caso, è necessario regolare il lato della manica dell'acceleratore del manubrio rasando con una lima.
*I segni di punzonatura su questo prodotto sono solo per riferimento. Si prega di regolare la posizione della maniglia a proprio piacimento.
*C'è un caso in cui il foro della scatola dell'interruttore di questo prodotto è leggermente fuori allineamento. In tal caso, può essere necessario modificarlo allargando il foro. Se siete pignoli circa l'installazione bolt-on, o se siete nervosi circa il costo del lavoro e il processo, vi consigliamo di consultare il negozio Honda Dream in anticipo.
*Si prega di notare che le specifiche del prodotto possono essere soggette a modifiche a causa della convenienza del produttore. Per favore, cerca di capire.
[Size*] W: 710 H: 100 R: 200 L: 130
[Handle diameter] 1 inch (25.4mm)
*W (Overall width) H (Height) R (Amount of pullback) L (Clamp section straight) Unit (mm)
*This product is approximately 65mm back and 3mm lower in height than the stock handle.
*Overall width is -5mm at the end of the stock lever.(Full width: ±20mm / height: ±40mm) No structural changes are required.
*This product does not require any changes to the hoses / harnesses / wires, but if you are concerned, please change the brake hoses to an appropriate length.Adjust the tension of the axle wire due to the changes in handling.
*The thickness of the paint on this product may vary.There may be a dullness when turning to the axle side.In this case, it is necessary to adjust the throttle sleeve side of the handlebar by shaving with a file.
*The punch marks on this product are for reference only.Please adjust the position of the handlebar to your liking.
*The holes in the switch box of this product may be slightly out of alignment.In this case, it is necessary to widen the hole.If you are a person who is finicky about bolt-on installation, or if you are nervous about the labor cost and process, it is recommended that you consult with your HONDA Dream shop beforehand.
*There may be changes in product specifications due to the manufacturer's reasons.