* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
We use cookies to provide and improve our services. By using our site, you consent to our Privacy Policy including cookie. Learn more
There is a little habit, but posture will be easier.
As NORMAL felt Handlebar farther, I changed it to EF - FIT Bar of EFFEX, but I changed it to this item because the change was too little to know the difference.
Position dramatically improved, but because of the shape quite different from NORMAL, especially the cornering feeling of discomfort is Large.
Replacement of Clutch Wire and Brake hose is necessary for replacement, so difficulty is higher for beginners. Especially Brake's Trouble leads to an accident, so we recommend you to replace it with a servicer.
In translation, it was decided to remove it after 1 month from installation, but the inside of Pipe was rusted and brown liquid came out. I think that water is entering from there because Plastic's Cap is just hanging in front. If you use it for a long time, I think that it is better to take out Cap once and do Waterproof treatment with Seal material etc..
I was 165 cm tall and I felt the OEMHandlebar felt so I was exchanging it with EFFEX EZ - FIT Bar, but I did not improve so much so I bought this product.
As a result, it was a very easy attitude. It is a feeling close to the off-road car that I was riding the previous time, but since the opening angle is Separate handle style, there is a slight incongruity until I get used to it. Since OEMMirror protrudes abnormally, Cross 2 (Quantity) of Napoleon previously purchased : Pair (for Left and Right) They are about 4 cm shorter, respectively). Handlebar Lock is OK.
Quantity with Brake hose and Clutch Wire : Set, so if there was a Parts cleaner for attaching and detaching Brake fluid and Handlebar Grip separately, if there was a glue, Grease kind, there was no problem with replacing with a tool on hand. Drilling is also Exactly.
I removed the Headlight part so that the routing of Brake hose is easy to do, but it may be okay if I do not remove it.
It took time and labor to exchange Brake hose so it was a failure to shy away from this product. If you do this from the beginning you would have done without wasting labor and cost...View Detail
Position of NORMAL by all means, it seems that it is searching and searching! First, Instruction Manual is not understood by English version (It does not help) The exchange itself is 1 hour if you know it. However, it took time to bleed Brake, so it was about 2 hours or so in the whole process. Position can not lower too much considering Clearance with Tank. However, it was a correct answer by exchanging it within a satisfactory range.View Detail
This is the only 'superbike kit' I could find for Ninja 400. Luckily, from Webike it's reasonably priced, given the low initial cost of the Ninja 400. The bike is said to have a relaxed riding position, as opposed to a sportier one in some other sport bikes, but for a shorter rider or an old dude like me a bit more upright riding position is a blessing. The kit contains all the hardware needed for installation, but like the website states, the instructions are only in Japanese. That means you must either have some idea how to work on bikes, or have a mechanic to install the kit for you. When removing old cables, tape an electrical wire on its end, pull the wire in its place, and then you can pull the new cable in place with the wire. That makes the job a lot easier. Right hand control cables (starter and engine stop switch) are a bit short after kit installation, so you would do best detaching the connector under the tank and re-routing the cables higher up in the frame for extra slack. Rest of the installation is pretty straight forward. Fit and finish of this kit is very good, well on par with the rest of the bike. The only complaint I have is about the throttle cables. The upper ends don't seem to be an exact match with the housing, so the throttle will be a bit stiffer to turn than originally. You can hear some scraping sound between parts when turning the throttle, and if you tighten the housing screws too much, the throttle won't return. I found a sweet spot where screws are tight enough, but there's still enough play for throttle tube to turn freely.All in all I'm pretty happy with this kit. Riding position is well improved. If Hurricane would see the trouble of creating installation instructions in other languages and fix the issues with the throttle cables I would give five stars. View Detail
cb1100ex의 순정 핸들 포지션은 굉장히 불편하고 애매한 라이딩 포지션입니다.그리고 제가 목디스크가 있어서 앞으로 조금 숙이는 자세가 헬멧 무게가 부담을 줘서 장거리 라이딩에 불편합니다.하지만 이 핸들바로 교체하면 포지션이 거90도로 변경되고 팔이나 어깨에 무리가 안갑니다.cb1100ex는 무조건 이핸들 입니다.View Detail
Original parts are the best and through Webike great service.Looks great on the motorcycle and really improves the style.More upright and excellent handling.View Detail
허리케인 핸들002형 정말 가성비 좋습니다.블랙페인팅이 되어 색상이 바이크와 잘 어울립니다.가공홀이 순정핸들바에 부착된 부품들과 잘 맞아 조립하는데에 문제가 없습니다.순정 분해시에 왼쪽 핸드그립이 잘 안빠지면 윤활제를 도포 후 제거 해보세요. 그리고 순정 핸들엔드는 앙카타입볼트만 있으면 재활용 됩니다.장착 후 포지션은 편합니다. 살짝 숙여지고 핸들폭이 작아져서 고속시에 더 유리할거 같습니다.이만한 가격에 가성비가 정말 훌륭하여 만족합니다.감사합니다.View Detail
?attachment The CBR650R is mounted at the same position angle as the NORMAL. However, when the handlebar was cut to the Left lock, it interfered with the interior cover next to the Meter, so the interior cover was cut away. I also purchased a 45° angled banjo adapter for the mesh hose to accommodate the tension of the mesh hose. ・NORMAL (Reserve integrated horizontal master) Impressions of No complaints on public roads. Familiar feel and very easy to handle. However, when the brake is set to "hard brake," the rate of increase in braking force relative to the input seems to decrease, and the brake becomes more forceful. Radipon (Reserve separate body portrait master) Impressions of It was totally different from what I expected, my expectation was that it would feel like a Rear brake… It is really a mild and easy-to-handle radipon. On public roads, it feels like NORMAL! I wonder if it's because NORMAL is the same NISSIN? But I felt the radipon effect from Breaking a little stronger, and It can be hung up to a hard brake without effort. I felt trust that this could stop.View Detail
I purchased this for use with multiple Helmets. 。 Mount included with the BOLD. Microphone and speaker are not included and must be purchased separately.View Detail
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING