- Used for Heat Guard on DUCATI 848.In the 1098 series, the Exhaust System meets under the thigh of the Right leg, so it gets unthinkably hot in a Japanese car.The external Carbon heat guard has already...Leggi di più
- I purchased this product because when I replaced the Tank with another color Tank on my SR400, the OEM Insulated Seat was not attached.The texture is thinner and harder than the OEM insulated Seat, bu...Leggi di più
- I noticed that the part where the Exhaust System was in contact with the external Under Cowl was slightly melted, so I hurriedly purchased this product. I drove several hundred kilometers after applyi...Leggi di più
- This Glass Wool is used for the exhaust pipes of the Exhaust System. It is relatively inexpensive and the material is easy to roll, so it is easy to work with.Leggi di più
- When I was looking for Heat Insulating Material to make Heat Guard.This product has been found (・∀・)It is less expensive than similar Insulation Glass Wool.The heat resistance temperature is re...Leggi di più
- I bought it to wrap around my 2-stroke Chamber.Wire and wire twister are necessary. It is necessary to make the appearance beautiful. It becomes a heat-shielding, but I am not sure whether the perform...Leggi di più
- My own motorcycle has a Center out, so my thighs and butt get hot, and it's an afterthought To protect electronic devices and pipes, etc. from heat, the inside of the heat shield and the exterior surf...Leggi di più
- I use it to protect my Under Cowl After about 10,000km of use, the silver foil-like part of the surface has come off, but Heat It seems to keep its performance as an Insulating Material, and for now, ...Leggi di più
- I installed it on the ZrX1200R where the back of the Fuel Tank is not heat resistantThis is a countermeasure against gasoline seepage from the tank capPreviously, the Cork Board and Material:I was wea...Leggi di più
- Even when compared with other company's product called ThermoGuard, appearance and quality did not change. Because making is also quite the same, the performance is probably the same. (Although DA...Leggi di più
- I bought it because the Under cowl center panel of my Motorcycle ZX - 12R melted with the heat of Exhaust pipe (sweat)When ordering a new OEMPanel with a Motorcycle shop, the price is 10,000 yen! What...Leggi di più
- Used for external Cowl of NSR 250. There is a part that comes in contact with the Exhaust Chamber, so I stuck it to the back as Cowl melted. How to use Cut to the appropriate Large dress with Scissors...Leggi di più
- When I have you make it a little larger slightly, it is that it is kind.
It was a Limit although we had expected it could use firmly by one sheet.
Leggi di più - It is used for RGV-gamma 250. Since the cowl was exchanged for the external new product, I stuck to the position which a chamber touches. Although such heat-resistant product is simple, it is not good...Leggi di più
- [Webike Monitor] It purchased in the heat-resistant measure against the Undercowl.
> -- the part which takes heat-resistant measures in mini neighborhood which is inserted into a favorite size, and o...Leggi di più - This product was purchased as a measure against heat of the neighborhood and a muffler to change the right side cowl of XR into the product made from FRP. Work is only the easy work cut and stuck on s...Leggi di più
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING